Difference between revisions of "AE Wifi Radio"

From Sharpfin
Jump to navigation Jump to search
Line 12: Line 12:
 
* The radio can now be taken apart. Be careful because front and back are still connected by the fragile flatcable and the two speaker cables.
 
* The radio can now be taken apart. Be careful because front and back are still connected by the fragile flatcable and the two speaker cables.
 
* The flatcable can be removed by gently pulling back the red plastic clips on the connector. This is all very fragile, and can easily break, so don't remove if there's no need to.
 
* The flatcable can be removed by gently pulling back the red plastic clips on the connector. This is all very fragile, and can easily break, so don't remove if there's no need to.
 +
 +
== PCB's ==
 +
 +
The AE is built on 3 PCB's
 +
 +
=== Main PCB ===
 +
 +
[[Image:ae_main_top.jpg|thump|Main PCB top view]]
 +
[[Image:ae_main_bottom.jpg|thump|Main PCB bottom view]]
 +
 +
=== Amplifier PCB ===
 +
 +
=== Button PCB ===

Revision as of 17:40, 8 November 2006

Opening the AE

This page describes how to open the AE radio. Most is easy, but take care when removing or connecting the flatcable, this is a fragile part of the radio's guts.

OPENING YOUR RADIO IS AT YOUR OWN RISK!!
Opening the AE (Click for a full-sized version)
  • Pull off the knob and remove the two small screws underneath.
  • Pull op the front of the rubber foot and remove the two smalls screws.
  • Remove the 4 screws in the deep holes.
  • The radio can now be taken apart. Be careful because front and back are still connected by the fragile flatcable and the two speaker cables.
  • The flatcable can be removed by gently pulling back the red plastic clips on the connector. This is all very fragile, and can easily break, so don't remove if there's no need to.

PCB's

The AE is built on 3 PCB's

Main PCB

Main PCB top view Main PCB bottom view

Amplifier PCB

Button PCB