Difference between revisions of "AE Wifi Radio"
Jump to navigation
Jump to search
OPENING YOUR RADIO IS AT YOUR OWN RISK!!
(→PCB's) |
|||
| Line 25: | Line 25: | ||
=== Amplifier PCB === | === Amplifier PCB === | ||
| + | |||
| + | <table><tr> | ||
| + | <td>[[Image:ae_amp_top.jpg|thumb|Amplifier PCB top view]]</td> | ||
| + | <td>[[Image:ae_amp_bottom.jpg|thumb|Amplifier PCB bottom view]]</td> | ||
| + | </tr></table> | ||
| + | |||
=== Button PCB === | === Button PCB === | ||
Revision as of 20:20, 8 November 2006
Opening the AE
This page describes how to open the AE radio. Most is easy, but take care when removing or connecting the flatcable, this is a fragile part of the radio's guts.
- Pull off the knob and remove the two small screws underneath.
- Pull op the front of the rubber foot and remove the two smalls screws.
- Remove the 4 screws in the deep holes.
- The radio can now be taken apart. Be careful because front and back are still connected by the fragile flatcable and the two speaker cables.
- The flatcable can be removed by gently pulling back the red plastic clips on the connector. This is all very fragile, and can easily break, so don't remove if there's no need to.
PCB's
The AE is built on 3 PCB's
Main PCB
File:Ae main top.jpg Main PCB top view |
File:Ae main bottom.jpg Main PCB bottom view |
Amplifier PCB
File:Ae amp top.jpg Amplifier PCB top view |
File:Ae amp bottom.jpg Amplifier PCB bottom view |
