AE Wifi Radio: Difference between revisions

From Sharpfin
Jump to navigation Jump to search
Line 19: Line 19:
=== Main PCB ===
=== Main PCB ===


[[Image:ae_main_top.jpg|thumb|Main PCB top view]]
<table><tr>
[[Image:ae_main_bottom.jpg|thumb|Main PCB bottom view]]
<td>[[Image:ae_main_top.jpg|thumb|Main PCB top view]]</td>
<td>[[Image:ae_main_bottom.jpg|thumb|Main PCB bottom view]]</td>
</tr></table>


=== Amplifier PCB ===
=== Amplifier PCB ===


=== Button PCB ===
=== Button PCB ===

Revision as of 16:56, 8 November 2006

Opening the AE

This page describes how to open the AE radio. Most is easy, but take care when removing or connecting the flatcable, this is a fragile part of the radio's guts.

OPENING YOUR RADIO IS AT YOUR OWN RISK!!
Opening the AE (Click for a full-sized version)
  • Pull off the knob and remove the two small screws underneath.
  • Pull op the front of the rubber foot and remove the two smalls screws.
  • Remove the 4 screws in the deep holes.
  • The radio can now be taken apart. Be careful because front and back are still connected by the fragile flatcable and the two speaker cables.
  • The flatcable can be removed by gently pulling back the red plastic clips on the connector. This is all very fragile, and can easily break, so don't remove if there's no need to.

PCB's

The AE is built on 3 PCB's

Main PCB

File:Ae main top.jpg
Main PCB top view
File:Ae main bottom.jpg
Main PCB bottom view

Amplifier PCB

Button PCB